IPC standards guide
A map of the standards that show up most in a board's life cycle — from design to assembly inspection. Always check the current revision in the official IPC document.
The three product classes
General electronic products
Consumer products where the main requirement is the function of the completed assembly.
Dedicated service
Industrial, communications and instrumentation equipment requiring continued performance and extended life; failures are undesirable but not critical.
High performance / harsh environment
Applications where downtime cannot be tolerated: life-support medical, aerospace, military. Stricter fabrication and inspection criteria.
Design
| Standard | Scope |
|---|---|
| IPC-2221 | Generic standard on printed board design: materials, spacing, conductors, holes, thermal data. |
| IPC-2222 | Sectional design requirements for rigid organic printed boards. |
| IPC-2226 | Design of HDI boards (microvias, high-density interconnect). |
| IPC-2141 | Design guide for high-speed controlled-impedance circuit boards. |
| IPC-2152 | Current-carrying capacity of conductors — the modern version of the heating curves. |
| IPC-7351 / 7352 | Land patterns (footprints) for SMD components: dimensions, density and naming. |
| IPC-7095 | Design and assembly process implementation for BGAs. |
Materials and bare-board fabrication
| Standard | Scope |
|---|---|
| IPC-4101 | Base materials specification (laminates and prepregs) by slash sheet. |
| IPC-4552 | ENIG finish (electroless nickel / immersion gold). |
| IPC-4761 | Via protection and treatment (tented, plugged, filled, capped). |
| IPC-6012 | Qualification and performance of rigid boards — defines Classes 1, 2 and 3. |
| IPC-A-600 | Visual acceptability criteria for printed boards. |
Assembly
| Standard | Scope |
|---|---|
| IPC-A-610 | Acceptability of electronic assemblies (the most widely used inspection standard). |
| J-STD-001 | Process requirements for soldered electrical and electronic assemblies. |
| IPC-7525 | Stencil design guidelines (solder paste apertures). |
| J-STD-033 | Handling, packing and baking of moisture-sensitive devices. |
| IPC-1601 | Printed board handling and storage. |
| IPC-7711/7721 | Rework, modification and repair of assemblies and boards. |
Data and transfer
| Standard | Scope |
|---|---|
| IPC-2581 | Open, intelligent fabrication and assembly data format. |
| IPC-D-356 | Netlist for bare-board electrical test. |
Important: this page is an educational summary. IPC standards are copyrighted documents and must be purchased from IPC. Contractual requirements apply as per the revision cited in the order.