LibraryIPC-7351

Footprints and padstacks per IPC-7351: naming, density and layers

How to name, draw and validate footprints in Allegro X with IPC-7351 rules and the Padstack Editor.

9 min read

Why standardize

A wrong footprint is an expensive mistake: the board is built and the part does not solder. IPC-7351 (evolving into IPC-7352) defines how to compute land dimensions from component, fabrication and assembly tolerances, and proposes a naming convention that describes the component in the name itself.

Naming

NameMeaning
RESC1608X55NChip resistor, 1.6 × 0.8 mm body, 0.55 mm height, nominal density (0603 imperial)
CAPC2012X125NChip capacitor, 2.0 × 1.2 mm, 1.25 mm height (0805)
SOIC127P600X175-8NSOIC, 1.27 mm pitch, 6.0 mm lead span, 1.75 mm height, 8 pins
QFP50P1200X1200X160-64NQFP, 0.5 mm pitch, 12 × 12 mm lead span, 1.6 mm height, 64 pins

The suffix indicates density: M (most — larger lands, more robust), N (nominal) and L (least — more compact). For most products, N is the starting point.

Padstacks in Allegro X

The Padstack Editor creates .pad files. For each layer you define:

  • Regular pad — the pad copper.
  • Thermal relief and anti-pad — connection to and isolation from planes (for plated holes).
  • Solder mask — mask opening, usually the pad plus an expansion agreed with the fabricator.
  • Paste mask — stencil aperture; on large thermal pads, split it into windows (IPC-7525).

The footprint (.dra/.psm)

  • Origin at the body center (or pin 1, per your standard) — consistent with the pick-and-place file.
  • Place bound with component height, for 3D and height checks.
  • Silkscreen off the pads, with a clear pin-1 mark.
  • Assembly outline and reference on the assembly layer.
  • Courtyard to guarantee room between components.
Render of a QFP with SMD resistors and capacitors
QFP and SMD passives: the land pattern defines the quality of the solder fillet.

Validation checklist: compare with the datasheet mechanical drawing, print at 1:1 scale and overlay the physical part, and check pin numbering against the schematic symbol.

References and further reading

Original text for educational purposes. Menus and commands may vary between Allegro X versions; check the Cadence documentation for your version.